Simple Touch Switch Circuit using IC 4017

A surprisingly simple touch sensor switch circuit could in fact be constructed utilizing just one IC 4017 together with a couple of supplementary passive elements, the method is spelled out in the next paragraphs .

Looking at the below presented circuit diagram for the suggested simple touch sensor switch, we are able to notice that the complete model has been designed around the IC 4017 which happens to be a 10 step johnson’s decade counter divider chip.

simple touch switch circuit

The IC fundamentally incorporates ten outputs, originating in its pin#3 and randomly finishing off at pin#11, constituting 10 outputs which are usually intended to develop a sequencing or switching high logics across all of these output pins based on every positive signal implemented at its pin#14.

The sequencing would not really need to accomplish at the last pin#11, instead may very well be allotted pull up at any preferred in between pinout, and then go back to the first pin#3 to begin the sequence afresh.

This is simply carried out by hooking up the last sequence pinout with the reset pin#15 of the IC. That makes certain that at any time the progression gets to this pinout, the sequence quits at this point and reverts to pin#3 which happens to be the first pinout for making it possible for a recurring cycling of the phase in an exact order.

As an illustration in our model pin#4 which is the 3rd pinout in the range can be viewed linked with pin#15 of the IC, means that while the progression leaps from pin#3 to the subsequent pin#2, thereafter to pin#4 it promptly reverts or flips returning to pin#3 to make it possible for the sequence yet again.

This cycling is brought on by touching the mentioned touch plate which in turn causes a positive signal to emerge at pin#14 of the IC whenever it’s touched.

Let’s anticipate at power launch the high logic is at pin#3, this pin is not associated anywhere as well as being empty, whilst pin#2 can be found associated with the relay driver stage, consequently at this point the relay continues turned OFF.

The minute the touch plate is tapped, the positive voltage at pin#14 of the IC toggles the output progression which at this point leaps from pin#3 to pin#2 making it possible for the relay to activate.

The situation is retained stationary at this stage, with the relay in the turned on situation as well as the plugged in load initialized.

But the instant the touch plate is handled just as before, the cycle is compelled to bounce from pin#2 to pin#4, which stimulates the IC to go back the logic returning to pin#3, stopping of the relay along with the load and helping the IC going back to its standby mode situation.