• Skip to main content
  • Skip to primary sidebar

Making Easy Circuits

Learn and build electronic circuits

You are here: Home / Archives for Dry

Dry Run Protector Circuits using Transistors only

Last Updated on December 29, 2024 by Admin Leave a Comment

motor2Bdry2Brunning2Bpreventor2Bcircuit

The basic dry run protection circuits using BJTs shown here provide simple ways to check for low water levels in an underground tank but without needing to use probes inside […]

Filed Under: Water Sensor and Controller Tagged With: Circuits, Dry, only, Protector, Run, Transistors

IC 555 Dry Run Protection Circuit

Last Updated on December 29, 2024 by Admin Leave a Comment

An preexisting circuit for an IC 555-based water level controller may be modified to include the dry run protection, as seen below: In the schematic above, the dry run function […]

Filed Under: Water Sensor and Controller Tagged With: 555, Dry, Protection, Run

Current Sensed Motor Dry Run Protector Circuit

Last Updated on December 28, 2024 by Admin Leave a Comment

Commonly dry run circuits mostly rely on water detection, which renders the designs quite antiquated and laborious. In contrast to these concept, the subsequent one relies on either load or current sensing […]

Filed Under: New Circuits Tagged With: Current, Dry, Motor, Protector, Run, Sensed

Dry Run Protection for Motor using Reed Relay Switch

Last Updated on December 28, 2024 by Admin Leave a Comment

When there exists no water in the tank and zero water is flowing out of the pipe plug, the pump motor could be equipped with an efficient dry run protection […]

Filed Under: New Circuits Tagged With: Dry, Motor, Protection, Reed, Relay, Run

Motor Dry Run Protection Circuit using IC4049

Last Updated on December 28, 2024 by Admin Leave a Comment

Six NOT gates from the IC 4049 may also be used to create a completely automatic version of a motor dry run protection circuit as seen below. This setup should operate […]

Filed Under: New Circuits Tagged With: Dry, IC4049, Motor, Protection, Run

Automatic Submersible Pump Controller Circuit with Dry Run Protection

Last Updated on January 7, 2025 by Admin 12 Comments

sub pump

This simple automatic submersible pump controller circuit equipped with a dry run protection will allow 3 parameters to be controlled using a a single chip circuit. Let’s learn the details […]

Filed Under: Water Sensor and Controller Tagged With: Automatic, Controller, Dry, Pump, Run, Submersible

Primary Sidebar

Categories

  • 3 Phase (4)
  • 8051 Microcontroller (1)
  • Arduino (11)
  • Audio and Amplifier (102)
  • Automation (8)
  • Battery Chargers (64)
  • Bicycle Projects (4)
  • Car and Motorcycle Projects (39)
  • Datasheets (10)
  • DIY Projects (5)
  • Electrical (15)
  • Free Energy (6)
  • Games Projects (2)
  • High Voltage (14)
  • Hobby Projects (30)
  • Household Circuits (2)
  • IC 555 Circuits (4)
  • Ignition Circuits (2)
  • Indicators (50)
  • Infrared (6)
  • Inverter Circuits (29)
  • Lights and Lamps (97)
  • Medical (8)
  • Meter and Tester Circuits (38)
  • Motor Driver (17)
  • New Circuits (56)
  • Oscillators (30)
  • Pets and Pests (5)
  • Power supply (81)
  • Protection Circuits (25)
  • PWM (8)
  • Remote Control (20)
  • Security and Alarm Circuit (48)
  • Sensors and Detectors (66)
  • Signal Processor (23)
  • Solar Controller Circuits (61)
  • SSR (3)
  • Temperature Controller (20)
  • Timer (25)
  • Transformerless (7)
  • Transmitters (12)
  • Tutorials (45)
  • UPS (2)
  • Voltage Regulators (57)
  • Water Sensor and Controller (29)
  • Home
  • Privacy Policy
  • Contact
  • Disclaimer
  • Copyright

© 2025 · Making Easy Circuits